ERG 2024 · Guide 133

Flammable Solids

UN1353 · Fabrics impregnated with weakly nitrated nitrocellulose, n.o.s.

Also listed as: Fibers impregnated with weakly nitrated nitrocellulose, n.o.s. · Fibres impregnated with weakly nitrated nitrocellulose, n.o.s.

Class 4.1

Flammable Solid placard (DOT 49 CFR §172)

CHEMTREC · 24/7

1-800-424-9300

Right now: Move upwind. Isolate 100 m minimum. Deny entry. Call CHEMTREC with shipping paper in hand.

More contacts →

Potential Hazards

Health

Fire may produce irritating and/or toxic gases.
Contact may cause burns to skin and eyes.
Contact with molten substance may cause severe burns to skin and eyes.
Runoff from fire control or dilution water may cause environmental contamination.

Fire or explosion

Flammable/combustible material.
May be ignited by friction, heat, sparks or flames.
Some may burn rapidly with flare-burning effect.
Powders, dusts, shavings, borings, turnings or cuttings may explode or burn with explosive violence.
Substance may be transported in a molten form at a temperature that may be above its flash point.
May re-ignite after fire is extinguished.

Public Safety

General

CALL 911. Then call emergency response telephone number on shipping paper. If shipping paper not available or no answer, refer to appropriate telephone number listed on the inside back cover.
Keep unauthorized personnel away.
Stay upwind, uphill and/or upstream.

Protective clothing

Wear positive pressure self-contained breathing apparatus (SCBA).
Structural firefighters' protective clothing provides thermal protection but only limited chemical protection.

Evacuation

Immediate precautionary measure
Isolate spill or leak area for at least 25 meters (75 feet) in all directions.
Large Spill
Consider initial downwind evacuation for at least 100 meters (330 feet).
Fire
If tank, rail tank car or highway tank is involved in a fire, ISOLATE for 800 meters (1/2 mile) in all directions; also, consider initial evacuation for 800 meters (1/2 mile) in all directions.

Emergency Response

Fire

Small Fire

Dry chemical, CO2, sand, earth, water spray or regular foam.

Large Fire

Water spray, fog or regular foam.
If it can be done safely, move undamaged containers away from the area around the fire.

Fire Involving Metal Pigments or Pastes (e.g. "Aluminum Paste")

Aluminum Paste fires should be treated as a combustible metal fire. Use DRY sand, graphite powder, dry sodium chloride-based extinguishers or class D extinguishers. Also, see GUIDE 170.

Fire Involving Tanks, Rail Tank Cars or Highway Tanks

Cool containers with flooding quantities of water until well after fire is out.
For massive fire, use unmanned master stream devices or monitor nozzles; if this is impossible, withdraw from area and let fire burn.
Withdraw immediately in case of rising sound from venting safety devices or discoloration of tank.
ALWAYS stay away from tanks in direct contact with flames.

Spill or leak

ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area.
Do not touch or walk through spilled material.
Small Dry Spill
With clean shovel, place material into clean, dry container and cover loosely; move containers from spill area.

Large Spill

Wet down with water and dike for later disposal.
Prevent entry into waterways, sewers, basements or confined areas.

First Aid

Refer to the “General First Aid” section.

Specific First Aid:

Removal of solidified molten material from skin requires medical assistance.